Today I will use some free time to carry on the knowledge learning of laser cutting, because this is an important aspect, and our understanding is not comprehensive and specific, so it is very necessary. So next, the editor will explain step by step, so that the content of the article is clear and easy for everyone to understand and master, for their own use. 1. The operating rules of Suzhou laser cutting and calibration equipment (1) Before the equipment starts to operate and use, the work site must be cleaned and arranged, and there should be no debris. The oil pipes, air pipes, wires and cables in the field should be organized to prevent them from being crushed and damaged during work. (2) For all joints of oil pipes, air pipes, etc., check whether the connections are tight, whether they are loose or damaged, and replace them immediately if they are damaged. (3) The hydraulic oil in the oil pump should be replaced regularly, and the oil tank should be cleaned during replacement. 2. Inspection standards for laser cutting in Suzhou (1) All kinds of components should be installed correctly. (2) The gap, etc., should be uniform and suitable. (3) The parts processed by Suzhou laser cutting can be used normally without any abnormality.